Please use this identifier to cite or link to this item: https://essuir.sumdu.edu.ua/handle/123456789/77028
Or use following links to share this resource in social networks: Recommend this item
Title AISI 1045 steel flat surfaces machining using the magneto-abrasive method
Authors Maiboroda, V.S.
Belajev, O.O.
Dzhulii, D.Yu.
Slobodianiuk, I.V.
ORCID
Keywords finishing
roughness
polishing
permanent magnet
magneto-abrasive tool
Type Article
Date of Issue 2020
URI https://essuir.sumdu.edu.ua/handle/123456789/77028
Publisher Sumy State University
License
Citation Maiboroda V. S., Belajev O. O., Dzhulii D. Yu., Slobodianiuk I. V. (2020). AISI 1045 steel flat surfaces machining using the magneto-abrasive method. Journal of Engineering Sciences, Vol. 7(1), pp. A1–A7, doi: 10.21272/jes.2020.7(1).a1
Abstract The results of the study of using the end-type heads based on permanent magnets for polishing flat surfaces of ferromagnetic parts on standard metal-working equipment are presented in the work. The possibility of a highly efficient achievement of the roughness of flat surfaces up to Ra < 0.05 μm with the initial Ra > 1–2 μm with removing of the heredity of the machining in the form of microwaves obtained in the face milling operation was shown. Based on the results of the analysis of the process of dispergation of the material was analyzed the influence of the magnetic field gradient the intensity of the magneto-abrasive machining of flat ferromagnetic surfaces by heads, which form a magneto-abrasive tool in the shape of a "brush" and "half of torus". The influence of technological process parameters: the rotation speed of the working heads, the sizes of the working gap, the technological feed on the character of the change in the microgeometry of the machined surface were investigated. The machining conditions, under which occur the preferential machining of micro peaks or micro valleys on a rough surface, were identified. It was determined that the rational conditions of the magneto-abrasive machining of flat ferromagnetic surfaces are: the rotation speed of the working heads 900 rpm, the gap size between the machined surface and the working surface of the head 2.5–4.0 mm and the working feed 10–15 mm/min.
Appears in Collections: Journal of Engineering Sciences / Журнал інженерних наук

Views

Algeria Algeria
1
Argentina Argentina
1
China China
740705555
Côte d’Ivoire Côte d’Ivoire
1
Germany Germany
1771446409
Hong Kong SAR China Hong Kong SAR China
1
Hungary Hungary
1
India India
1
Indonesia Indonesia
1
Iran Iran
740705551
Iraq Iraq
1
Ireland Ireland
177173794
Latvia Latvia
1
Lithuania Lithuania
1
Netherlands Netherlands
51392588
Nigeria Nigeria
4482447
Romania Romania
1
Rwanda Rwanda
1
Slovenia Slovenia
1
Sweden Sweden
1
Thailand Thailand
1
Ukraine Ukraine
148018
United Kingdom United Kingdom
70460741
United States United States
-2106753957
Unknown Country Unknown Country
790531614
Vietnam Vietnam
16627

Downloads

China China
740705556
Germany Germany
4461
Hungary Hungary
1
India India
15
Indonesia Indonesia
1
Iran Iran
97755
Ireland Ireland
51392586
Lithuania Lithuania
1
Tunisia Tunisia
1
Ukraine Ukraine
921075027
United Kingdom United Kingdom
2075449161
United States United States
740705558
Unknown Country Unknown Country
1
Vietnam Vietnam
1

Files

File Size Format Downloads
Maiboroda_jes_1_2020.pdf 734.68 kB Adobe PDF 234462829

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.