Please use this identifier to cite or link to this item: https://essuir.sumdu.edu.ua/handle/123456789/93157
Or use following links to share this resource in social networks: Recommend this item
Title A novel force control strategy for improved surface integrity in low plasticity burnishing
Authors Livatyali, H.
ORCID
Keywords ball burnishing
residual stress
finite element analysis
process innovation
Type Article
Date of Issue 2023
URI https://essuir.sumdu.edu.ua/handle/123456789/93157
Publisher Sumy State University
License Creative Commons Attribution - NonCommercial 4.0 International
Citation Livatyali H. (2023). A novel force control strategy for improved surface integrity in low plasticity burnishing. Journal of Engineering Sciences (Ukraine), Vol. 10(2), pp. A18–A26, doi: 10.21272/jes.2023.10(2).a3
Abstract Ball burnishing is a cold work process where a hard ceramic or diamond ball rolls on a metal surface and flattens the roughness peaks under high local pressure. The small deformation created on the surface imposes compressive residual stresses and raises hardness in a shallow sub-surface layer, leading to improved fatigue, corrosion, and foreign object damage performances. Trial-and-error type experimental work to determine the optimum process parameters for a cold-forming process like ball burnishing for acceptable performance is costly. Therefore, the article aims to investigate the effects of various force control strategies in the double-sided low plasticity burnishing (LPB) process to find the effects on deformation and residual stresses on thin Ti6Al4V flat sheets. A 3D static-implicit finite element model was developed with an elastic-rigid plastic flow curve. Simulations were conducted to predict residual stresses and deformationі on the surface. As a result, it was proven that ball burnishing can produce a deterministically controlled surface. An increased vertical force produced higher deformation normal to the surface and, therefore, a deeper pool. As the ball proceeded further, a plowing effect developed such that when a 3.5–4.8 m deep pool was formed (at a vertical force of 150 N), a peak of 2.8 m was produced at the front end. Overall, the deformation on the surface and the residual stresses were directly interrelated. Parallel to the deformation on the surface, residual stresses on and beneath the surface also showed some variation. Nevertheless, the predicted residual stress variations were not big. They did not switch to the tensile mode in the burnished zone. Therefore, the whole sheet surface should be burnished to obtain all the compressive residual stresses.
Appears in Collections: Journal of Engineering Sciences / Журнал інженерних наук

Views

India India
1
Indonesia Indonesia
1
Iran Iran
7674
Ireland Ireland
5
Japan Japan
1
Mexico Mexico
1
Sweden Sweden
3836
Turkey Turkey
390
Ukraine Ukraine
388
United States United States
7671
Unknown Country Unknown Country
115

Downloads

Austria Austria
1
Finland Finland
1
France France
21
Japan Japan
3835
Poland Poland
1
Singapore Singapore
1
Spain Spain
1
Sweden Sweden
3837
Turkey Turkey
20084
Ukraine Ukraine
1
United States United States
7675

Files

File Size Format Downloads
Livatyali_jes_2_2023.pdf 825.36 kB Adobe PDF 35458

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.