Please use this identifier to cite or link to this item: https://essuir.sumdu.edu.ua/handle/123456789/82298
Or use following links to share this resource in social networks: Recommend this item
Title Contact of working surfaces for spherical washers and recommendations for determining the gap in the joint
Authors Dehtiarov, Ivan Mykhailovych
Neshta, Anna Oleksandrivna
Samardak, M.P.
Antosz, K.
Avramenko, S.E.
Keywords lapping
turning
tolerance
contact square
manufacturability
Type Article
Date of Issue 2020
URI https://essuir.sumdu.edu.ua/handle/123456789/82298
Publisher Sumy State University
License Creative Commons Attribution - NonCommercial 4.0 International
Citation Dehtiarov I. M., Neshta A. O., Samardak M. P., Antosz K., Avramenko S. E. (2020). Contact of working surfaces for spherical washers and recommendations for determining the gap in the joint. Journal of Engineering Sciences, Vol. 7(2), pp. B1–B7, doi: 10.21272/jes.2020.7(2).b1
Abstract In article analyzes the technical requirements for spherical washers used in threaded connections of pumps, which made it possible to highlight contradictions in paragraphs of the current standards for pump fasteners. They regarding recommendations for manufacturing technology and control of the working surfaces of washers. Publication analysis in the spherical surfaces lapping showed the absence of research in the spherical surfaces contact after lapping and the dependence of contact parameters by the technological parameters for this operation. The presence of a gap in conjunction with spherical washers after the lapping process was proved geometrically. Its location was determined, and a mathematical dependence was obtained to determine the maximum gap value in conjunction. It was found that the gap depends on the design parameters of the washers' conjunction and the abrasive material grain size used for lapping. Recommendations for selecting the abrasive material grain size for the lapping operation for the most common values of the roughness parameters for the working surfaces of spherical washers have been formed. In the article was proposed to introduce into the technical requirements for the spherical washers drawings changes concerning the gap size allowable in the conjunction, and as well as tolerances value changes of the radii of the working surfaces of the washers, thus increasing their manufacturability without conflicting with the requirements of the current standards.
Appears in Collections: Journal of Engineering Sciences / Журнал інженерних наук

Views

China China
523
Germany Germany
1
Israel Israel
1
Lithuania Lithuania
1
Netherlands Netherlands
10672
Nigeria Nigeria
1
Sweden Sweden
1
Ukraine Ukraine
528
United Kingdom United Kingdom
1
United States United States
6709
Unknown Country Unknown Country
1
Vietnam Vietnam
2748

Downloads

Israel Israel
1
Japan Japan
1
Ukraine Ukraine
47
United Kingdom United Kingdom
1
United States United States
10674
Vietnam Vietnam
1

Files

File Size Format Downloads
Dehtiarov_jes_2_2020.pdf 963,3 kB Adobe PDF 10725

Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.